Launch MacRemover in the dock or Launchpad, select TeamViewer appearing on the interface, and click Run Analysis button to proceed. Follow the prompts to finish the uninstallation of the software. Select the program you wish to remove and right click then select Uninstall/Change. Under Programs click the Uninstall a Program link. From the Start Menu, select Control Panel.
Click on that to activate the Take Control integration.Windows uninstall instructions. This adds a Replace with Take Control link to the device in the dashboard. From the dashboard, edit the device and turn on Take Control. Give up on the stand-alone version of TeamViewer, at least temporarily.Figure out which registry keys need to be changed and change them via the command prompt.Complete the steps here to Start TeamViewer with Windows. Find another way to access the computer, or have the user work with you.Take Control – Existing Installation – Integration Requires "Start With Windows" Set Unfortunately at this point you are left with the following message in the dashboard: If TeamViewer 10 was installed via Patch Management, change that patch from Approve to Ignore so it doesn’t upgrade again. On the Remote Service Control tab of Remote Desktop, you should see the TeamViewer 9 service running.įrom the MAXfocus dashboard, re-run checks to get to to pick up the TeamViewer integration again. Then install the previous version:Ĭheck the Program Files (x86)\TeamViewer\Version9 folder to confirm that Version 9 is there. Give it a minute and make sure the TeamViewer folder is empty. "%programfiles(x86)%\TeamViewer\uninstall.exe" /S If I didn’t, I’d have to write a script to download it. Also, the service name is just “TeamViewer” without a version suffix.įortunately, I still have the TeamViewer 9 installer in a folder called C:\Install on the remote computer. TeamViewer Version 10 gets installed in the Program Files (x86)\TeamViewer folder, not in a subfolder. Posts here and here explain that the /S switch (must be capitalized) can be used for silent uninstall and re-install of TeamViewer using the. I only have command-line access to the machine via the MAXfocus Remote Background prompt. I need to downgrade TeamViewer from 10 to 9 to re-gain compatibility with MAXfocus. I approved an upgrade to TeamViewer 10 and lost TeamViewer access to a machine from the MAXfocus dashboard.
0 kommentar(er)
